IEC 60317-4:2015 绕组线的规格 - 第4部分:可焊性聚氨酯漆包铜线 130级

标准编号：IEC 60317-4:2015

中文名称：绕组线的规格 - 第4部分:可焊性聚氨酯漆包铜线 130级

英文名称：Specifications for particular types of winding wires - Part 4: Solderable polyurethane enamelled round copper wire, class 130

发布日期：2015-06-09

标准范围

IEC 60317-4:20 15规定了130级可焊接漆包圆铜绕组线的要求，其底涂层基于聚氨酯树脂，只要保留原始树脂的化学特性并满足所有规定的电线要求，就可以对其进行修改。本标准涵盖的公称导体直径范围为:-1级:0,018 mm至2,000 mm并包括2,000 mm；-2级:0,020毫米至2,000毫米（含2,000毫米）。IEC 60317-0-1:20 13第4条规定了标称导体直径。这第四版取消并取代了1990年出版的第三版，修正案1:19 97和修正案2:19 99。本版构成技术修订版。与上一版相比，此版本包括以下重大技术变更:-新的3.2.2载有关于绕组线的一般说明，以前是范围的一部分；-新的3.2.3包含外观要求；-修订IEC 60317-0-1:20 13的参考文献，以阐明其应用是规范性的；-合并17.1和17.2的可焊性要求；-修订第19条，介电耗散系数；-新订的第23条，针孔测试。关键词:绕组用绝缘导线

IEC 60317-4:2015 specifies the requirements of solderable enamelled round copper winding wire of class 130 with a sole coating based on polyurethane resin, which may be modified provided it retains the chemical identity of the original resin and meets all specified wire requirements. The range of nominal conductor diameters covered by this standard is:
- Grade 1: 0,018 mm up to and including 2,000 mm;
- Grade 2: 0,020 mm up to and including 2,000 mm. The nominal conductor diameters are specified in Clause 4 of IEC 60317-0-1:2013. This fourth edition cancels and replaces the third edition published in 1990, Amendment 1:1997 and Amendment 2:1999. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition:
- new 3.2.2 containing general notes on winding wire, formerly a part of the scope;
- new 3.2.3 containing requirements for appearance;
- revision to references to IEC 60317-0-1:2013 to clarify that their application is normative;
- consolidation of 17.1 and 17.2 of the solderability requirements;
- revision to Clause 19, dielectric dissipation factor;
- new Clause 23, pin hole test.Keywords: insulated wires used for windings

标准预览图