ISO 18595:2007 电阻焊 铝和铝合金的点焊 可焊性、焊接和测试

标准编号：ISO 18595:2007

中文名称：电阻焊 铝和铝合金的点焊 可焊性、焊接和测试

英文名称：Resistance welding — Spot welding of aluminium and aluminium alloys — Weldability, welding and testing

发布日期：2007-09

标准范围

ISO 18595:2007规定了制造铝板组件、挤压件（加工硬化和时效硬化合金）和/或铸造材料（包括两种或三种金属厚度）时的电阻点焊要求，其中待焊接部件的最大单（板）厚度在0.6 mm至6 mm范围内。ISO 18595:2007适用于厚度比小于或等于3:1的不同厚度薄板或板材的焊接。适用于总厚度小于或等于9 mm的三种厚度的焊接。使用以下类型的机器进行焊接符合ISO 18595的范围:2007年:底座焊接机；枪焊工；由机器人或自动送料设备送料的自动焊接设备；多焊工；机器人焊工。涂层材料（例如镀锌或阳极材料）的焊接不在ISO 18595:2007的范围内。

ISO 18595:2007 specifies requirements for resistance spot welding in the fabrication of assemblies of aluminium sheet, extrusions (both work- and age-hardening alloys) and/or cast material comprising two or three thicknesses of metal, where the maximum single (sheet) thickness of components to be welded is within the range 0,6 mm to 6 mm.ISO 18595:2007 is applicable to the welding of sheets or plates of dissimilar thickness where the thickness ratio is less than or equal to 3:1. It applies to the welding of three thicknesses where the total thickness is less than or equal to 9 mm.Welding with the following types of machines is within the scope of ISO 18595:2007: pedestal welding machines; gun welders; automatic welding equipment where the components are fed by robots or automatic feeding equipment; multi-welders; robotic welders.The welding of coated material, e. g. zinc coated or anodised material, is not within the scope of ISO 18595:2007.

标准预览图