IEC TS 62351-100-1:2018 电力系统管理和相关信息交换.数据和通信安全.第100-1部分:IEC TS 62351-5和IEC TS 60870-5-7的一致性测试用例

标准编号：IEC TS 62351-100-1:2018

中文名称：电力系统管理和相关信息交换.数据和通信安全.第100-1部分:IEC TS 62351-5和IEC TS 60870-5-7的一致性测试用例

英文名称：Power systems management and associated information exchange - Data and communications security - Part 100-1: Conformance test cases for IEC TS 62351-5 and IEC TS 60870-5-7

发布日期：2018-11-07

标准范围

IEC TS 62351-100-1:20 18(E)是一项技术规范，描述了远动设备、变电站自动化系统(SAS)和远动系统的数据和通信安全测试用例，包括SCADA的前端功能。本文档的目标是通过提供测试协议实现的标准方法来验证设备是否满足标准的要求，从而实现互操作性。请注意，符合标准并不能保证使用不同实现的设备之间的互操作性。预计在测试期间使用该规范将最大限度地降低非互操作性的风险。这种互操作性的基本条件是两个设备都通过了一致性测试。本文件的范围是规定IEC TS 62351-的一致性和/或互操作性测试的常用程序和定义。5和IEC TS 60870-5-7。如IEC TS 62351-5和IEC TS 60870-5-7中规定的，本文定义的一致性测试用例集中于验证底层认证的一致性集成，以保护基于IEC 60870-5-101和IEC 6870-5-104的通信。本文档涉及数据和通信安全一致性测试；因此，不包括其他要求，如安全性或EMC。这些要求由其他标准（如果适用）涵盖，这些主题的合规性证明是根据这些标准完成的。

IEC TS 62351-100-1:2018(E), which is a technical specification, describes test cases of data and communication security for telecontrol equipment, substation automation systems (SAS) and telecontrol systems, including front-end functions of SCADA.
The goal of this document is to enable interoperability by providing a standard method of testing protocol implementations to verify that a device fulfils the requirement of the standard. Note that conformity to the standard does not guarantee interoperability between devices using different implementations. It is expected that using this specification during testing will minimize the risk of non-interoperability. A basic condition for this interoperability is a passed conformance test of both devices.
The scope of this document is to specify commonly available procedures and definitions for conformance and/or interoperability testing of IEC TS 62351-5 and IEC TS 60870-5-7. The conformance test cases defined herein are focused to verify the conformant integration of the underlying authentication, as specified in IEC TS 62351-5 and IEC TS 60870-5-7, to protect IEC 60870-5-101 and IEC 6870-5-104-based communications.
This document deals with data and communication security conformance testing; therefore, other requirements, such as safety or EMC, are not covered. These requirements are covered by other standards (if applicable) and the proof of compliance for these topics is done according to these standards.

标准预览图