IEC 60317-0-7:2017 特种绕组线规范第0-7部分:一般要求全绝缘（FIW）无缺陷漆包圆铜线

标准编号：IEC 60317-0-7:2017

中文名称：特种绕组线规范第0-7部分:一般要求全绝缘（FIW）无缺陷漆包圆铜线

英文名称：Specifications for particular types of winding wires - Part 0-7: General requirements - Fully insulated (FIW) zero-defect enamelled round copper wire

发布日期：2017-08-16

标准范围

IEC 60317-0-7:20 17制定了全绝缘（FIW）零缺陷漆包圆铜线的一般要求。公称导体直径范围在相关技术规范中给出。第二版取消并取代了2012年出版的第一版。此版本构成技术修订。？与上一版相比，此版本包括以下重大技术变更:-将FIW的等级从3至9减少到仅4、6和8；-将线直径范围从(0,040至1,000)mm减小至(0,090至0,900)mm以满足若干要求；-修订第5条，删除表2阻力要求；-修订第13条，以澄清当达到计算出的最小测试电压时确定击穿，该电压可以小于10 000 V；-扩展附件A，以包括FIW 3、5、7和9以及所有等级的要求，电线直径小于0,090毫米和大于0,900毫米。

IEC 60317-0-7:2017 establishes general requirements for fully insulated (FIW) zero-defect enamelled round copper wires. The nominal conductor diameter range is given in the relevant technical specification. This second edition cancels and replaces the first edition published in 2012. This edition constitutes a technical revision.？ This edition includes the following significant technical changes with respect to the previous edition:
- reduction in the number of grades of FIW from 3 through 9 to 4, 6 and 8 only;
- reduction of the wire diameter range from (0,040 to 1,000) mm to (0,090 to 0,900) mm for several requirements;
- revision of Clause 5 to delete the Table 2 resistance requirements;
- revision of Clause 13 to clarify that breakdown is determined when a calculated minimum test voltage is reached, which can be less than 10 000 V;
- expansion of Annex A to include requirements for FIW 3, 5, 7 and 9 and for all grades, wire diameters below 0,090 mm and above 0,900 mm.

标准预览图