IEC 62031:2018 一般照明的LED模块 - 安全规格

标准编号：IEC 62031:2018

中文名称：一般照明的LED模块 - 安全规格

英文名称：LED modules for general lighting - Safety specifications

发布日期：2018-03-08

标准范围

新的！IEC 62031:2018作为IEC 62031:2018 RLV提供，其中包含国际标准及其红线版本，显示了与上一版本相比技术内容的所有变化。IEC 62031:2018规定了发光二极管(LED)模块的一般和安全要求:-用于在恒定电压、恒定电流或恒定功率下操作的非集成LED模块(LEDni模块)和半集成LED模块(LEDsi模块)；-集成LED模块（LEDi模块），用于最高250 V的DC电源或最高1000 V的AC电源，频率为50 Hz或60 Hz。本第二版取消并取代了2008年出版的第一版、修正案1:20 12和修正案2:20 14。本版构成技术修订版。与上一版相比，此版本包括以下重大技术变更:a.澄清了范围以及其他几项条款的措辞；b.更新了规范性参考文献；c.引入了“可更换LED模块”、“不可更换LED模块”和“非用户可更换LED模块”的定义，而IEC 62504涵盖的其他定义已被删除；d.对标记条款进行了重组，并增加了一个表格，以提供信息丰富的概述；e.更改了内置LED模块的标记要求；f.修改了工作电压标记的条目；g.修订了码头和热管理规定；h.删除附件B；i.介绍了关于工作电压和水接触的灯具设计信息；j.引入了异常温度测试。

NEW!IEC 62031:2018 is available as IEC 62031:2018 RLV which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.

IEC 62031:2018 specifies general and safety requirements for light-emitting diode (LED) modules:
- non-integrated LED modules (LEDni modules) and semi-integrated LED modules (LEDsi modules) for operation under constant voltage, constant current or constant power;
- Integrated LED modules (LEDi modules) for use on DC supplies up to 250 V or AC supplies up to 1 000 V at 50 Hz or 60 Hz.
This second edition cancels and replaces the first edition published in 2008, Amendment 1:2012 and Amendment 2:2014. This edition constitutes a technical revision.
This edition includes the following significant technical changes with respect to the previous edition:
a. the scope was clarified as well as the wording in several other clauses;
b. the normative references were updated;
c. the definitions for "replaceable LED module", "non-replaceable LED module" and "non-user replaceable LED module" were introduced while other definitions covered by IEC 62504 have been removed;
d. the marking clause was restructured and a table added to provide an informative overview;
e. the marking requirements for built-in LED modules were changed;
f. the entry for the marking with the working voltage was revised;
g. the provisions for terminals and heat management were revised;
h. Annex B was deleted;
i. information for luminaire design with regard to working voltage and water contact was introduced;
j. an abnormal temperature test was introduced.

标准预览图