IEC PAS 60512-27-200:2018 电气和电子设备用连接器.试验和测量.第27-200部分:IEC 60603-7系列连接器上2000MHz以下信号完整性试验的附加规范.试验27a至27g
标准编号:IEC PAS 60512-27-200:2018
中文名称:电气和电子设备用连接器.试验和测量.第27-200部分:IEC 60603-7系列连接器上2000MHz以下信号完整性试验的附加规范.试验27a至27g
英文名称:Connecteurs for electrical and electronic equipment - Tests and measurements - Part 27-200: Additional specifications for signal integrity tests up to 2 000 MHz on IEC 60603-7 series connectors - Tests 27a to 27g
发布日期:2018-10-19
标准范围
IEC/PAS 60512-27-200:2018涵盖了IEC 60512-27-100的信号完整性和传输性能测试方法的附加补充规范,用于使用去嵌入式串扰测量的连接器,这些规范在IEC 60603-7标准的相应部分中规定,用于连接高达2 000 MHz的硬件应用。这些附加规范也适用于测试相关的低频连接器。然而,详细规范中为任何给定连接器规定的测试方法仍然是该连接器的参考一致性测试。受这些补充方法和程序影响的IEC 60512-27-100测试程序有:?插入损耗,测试27a;?回波损耗,测试27b;?近端串扰(下一个)测试27c;?远端串扰(FEXT),测试27d;?横向转换损耗(TCL),测试27f;?横向转换传递损失(TCTL),测试27g。此处引用的其他测试程序有:?传递阻抗(ZT),参见IEC 62153-4-6或IEC 62153-4-7中的测试程序。?对于耦合衰减(aC),参见IEC 62153-4-7或IEC 62153-4-12中的测试程序。关键词:连接器信号完整性
IEC/PAS 60512-27-200:2018 covers additional, supplemental specifications for signal integrity and transmission performance test methods of IEC 60512-27-100, for connectors using de-embedded crosstalk measurements, which are specified in respective parts of IEC 60603-7 standards for connecting hardware applications up to 2 000 MHz.
These additional specifications are also applicable for testing the related lower frequency connectors. However, the test methodology specified in the detail specification for any given connector remains the reference conformance test for that connector.
Test procedures of IEC 60512-27-100 affected by these supplemental methods and procedures are:
? insertion loss, test 27a;
? return loss, test 27b;
? near-end crosstalk (NEXT) test 27c;
? far-end crosstalk (FEXT), test 27d;
? transverse conversion loss (TCL), test 27f;
? transverse conversion transfer loss (TCTL), test 27g.
Other test procedures referenced here are:
? transfer impedance (ZT), see test procedures in IEC 62153-4-6 or IEC 62153-4-7.
? for coupling attenuation (aC), see test procedures in IEC 62153-4-7 or IEC 62153-4-12.
Keywords: Connector, Signal Integrity
标准预览图


