IEC 60060-2:2010 高压测试技术 - 第2部分:测量系统

标准编号：IEC 60060-2:2010

中文名称：高压测试技术 - 第2部分:测量系统

英文名称：High-voltage test techniques - Part 2: Measuring systems

发布日期：2010-11-29

标准范围

IEC 60060-2:20 10适用于完整的测量系统及其组件，用于在实验室和工厂测试期间测量IEC 60060-1中规定的直流电压、交流电压以及雷电和开关冲击电压的高压。有关现场测试期间的测量，请参见IEC 60060-3。本标准中规定的测量不确定度限值适用于IEC 60071-1:20 06中规定的测试水平。本标准的原则也适用于更高的水平，但不确定性可能更大。本标准还定义了所使用的术语、估计高压测量不确定度的方法，陈述了测量系统应满足的要求，描述了批准测量系统和检查其组件的方法，并描述了用户应证明测量系统满足本标准要求的程序，包括为测量不确定度设定的限值。第三版取消并取代了1994年出版的第二版，构成了技术修订。与上一版相比的重大技术变更如下:-更新和改进了总体布局和文本，使标准更易于使用。-修订了该标准，使其与IEC 60060-1保持一致。——扩展了测量不确定度估计的处理。

IEC 60060-2:2010 is applicable to complete measuring systems, and to their components, used for the measurement of high voltages during laboratory and factory tests with direct voltage, alternating voltage and lightning and switching impulse voltages as specified in IEC 60060-1. For measurements during on-site tests see IEC 60060-3. The limits on uncertainties of measurements stated in this standard apply to test levels stated in IEC 60071-1:2006. The principles of this standard apply also to higher levels but the uncertainty may be greater. This standard also defines the terms used, methods to estimate the uncertainties of high-voltage measurements, states the requirements which the measuring systems shall meet, describes the methods for approving a measuring system and checking its components and describes the procedures by which the user shall show that a measuring system meets the requirements of this standard, including the limits set for the uncertainty of measurement. This third edition cancels and replaces the second edition, published in 1994, and constitutes a technical revision. The significant technical changes with respect to the previous edition are as follows:
- The general layout and text was updated and improved to make the standard easier to use.
- The standard was revised to align it with IEC 60060-1.
- The treatment of measurement uncertainty estimation has been expanded.

标准预览图