IEC TS 62196-3-1:2020 插头、插座、车辆连接器和车辆插孔.电动汽车的传导充电.第3-1部分:与热管理系统一起使用的直流充电用车辆连接器、车辆插孔和电缆组件

标准编号：IEC TS 62196-3-1:2020

中文名称：插头、插座、车辆连接器和车辆插孔.电动汽车的传导充电.第3-1部分:与热管理系统一起使用的直流充电用车辆连接器、车辆插孔和电缆组件

英文名称：Plugs,socket-outlets, vehicle connectors and vehicle inlets - Conductive charging of electric vehicles - Part 3-1: Vehicle connector, vehicle inlet and cable assembly for DC charging intended to be used with a thermal management system

发布日期：2020-03-26

标准范围

IEC TS 62196-3-1:20 20(E)适用于与IEC 62196-3:20 14中规定的配置相同、额定工作电压不超过1 500 V DC、额定电流不超过500 A的附件和电缆组件-热感测，或-具有4.101中描述的系统架构的热传输和热感测。这些附件和电缆组件旨在用于IEC 61851-23中规定的电路的导电充电系统。注:IEC 61851-23第2版正在开发中。本文档涵盖的附件旨在根据IEC 61851-1在充电模式4中使用。这些附件旨在根据直流电缆的IEC 62893系列连接到电缆上。

IEC TS 62196-3-1:2020(E) applies to accessories and cable assemblies with the same configuration as specified in IEC 62196-3:2014 with rated operating voltage not exceeding 1 500 V DC and a rated current not exceeding 500 A that employ
- thermal sensing, or
- thermal transport and thermal sensing with the system architecture described in 4.101.
These accessories and cable assemblies are intended to be used in conductive charging systems for circuits specified in IEC 61851-23.
NOTE Edition 2 of IEC 61851-23 is under development.
The accessories covered by this document are intended to be used in charging mode 4 according to IEC 61851-1. These accessories are intended to be connected to cables according to the IEC 62893 series for DC cables.

标准预览图