ISO 17892-12:2018 岩土调查和试验 土壤的实验室试验 第12部分：液体和塑料限度的测定

标准编号：ISO 17892-12:2018

中文名称：岩土调查和试验 土壤的实验室试验 第12部分：液体和塑料限度的测定

英文名称：Geotechnical investigation and testing — Laboratory testing of soil — Part 12: Determination of liquid and plastic limits

发布日期：2018-06

标准范围

本文件规定了测定土壤液限和塑限的方法。这包括土壤的两个阿太堡极限。液限是土壤从液态变为塑性状态时的含水量。本文件描述了天然土壤样品的液限测定，或去除了大于0.4mm材料的土壤样品的液限测定。本文件描述了两种方法:落锥法和卡萨格兰德法。注:本文件中的落锥法不应与ISO 17892-6中的方法混淆。土壤的塑性极限是土壤进一步干燥时不再具有塑性的含水量。塑性极限的测定通常与液限的测定同时进行。我们认识到，试验结果取决于操作员的判断，结果会出现一些变化。

This document specifies methods for the determination of the liquid and plastic limits of a soil. These comprise two of the Atterberg limits for soils.

The liquid limit is the water content at which a soil changes from the liquid to the plastic state.

This document describes the determination of the liquid limit of a specimen of natural soil, or of a specimen of soil from which material larger than about 0,4 mm has been removed. This document describes two methods: the fall cone method and the Casagrande method.

NOTE The fall cone method in this document should not be confused with that of ISO 17892？6.

The plastic limit of a soil is the water content at which a soil ceases to be plastic when dried further.

The determination of the plastic limit is normally made in conjunction with the determination of the liquid limit. It is recognized that the results of the test are subject to the judgement of the operator, and that some variability in results will occur.

标准预览图