ISO 1268-10:2005 纤维增强塑料-试验板的制备方法 第10 部分： BMC注塑成型和其他长-纤维铸成混合物 一般原则和多用途测试样品的成型

标准编号：ISO 1268-10:2005

中文名称：纤维增强塑料-试验板的制备方法 第10 部分： BMC注塑成型和其他长-纤维铸成混合物 一般原则和多用途测试样品的成型

英文名称：Fibre-reinforced plastics — Methods of producing test plates — Part 10: Injection moulding of BMC and other long-fibre moulding compounds — General principles and moulding of multipurpose test specime

发布日期：2005-02

标准范围

ISO 1268-10:2005规定了对散装模塑化合物（BMC）试样进行注射成型时应遵循的一般原则，并给出了制备一种试样用于建立可再现成型条件的模具设计细节。在适当情况下，ISO 1268的本部分可适用于为注射成型而配制的片状模塑料（SMC）。其目的是促进描述模塑工艺主要参数的一致性，并建立报告模塑条件的统一实践。对于所使用的每种材料，可重复制备试样所需的特殊条件将有所不同，从而产生可比结果。这些条件在相关材料的国际标准中给出，或由相关方商定。

ISO 1268-10:2005 specifies the general principles to be followed while injection moulding test specimens of bulk moulding compound (BMC) and gives details of mould designs for preparing one type of specimen for use in establishing reproducible moulding conditions. Where appropriate, this part of ISO 1268 may be applied to sheet moulding compound (SMC) formulated for injection moulding. Its purpose is to promote uniformity in describing the main parameters of the moulding process and also to establish uniform practice in reporting moulding conditions. The particular conditions required for the reproducible preparation of test specimens which will give comparable results will vary for each material used. These conditions are given in the International Standard for the relevant material or are to be agreed upon between interested parties.

标准预览图