ISO 12614-3:2021 公路车辆 液化天然气（LNG）燃油系统组件 第3部分：止回阀
标准编号：ISO 12614-3:2021
中文名称：公路车辆 液化天然气（LNG）燃油系统组件 第3部分：止回阀
英文名称：Road vehicles — Liquefied natural gas (LNG) fuel system components — Part 3: Check valve
发布日期：2021-06
标准范围
本文件规定了止回阀的测试和要求，止回阀是一种液化天然气燃料系统部件，用于ISO？3833.本文件不适用于以下情况:a)燃料容器；b)固定式燃气发动机；c)容器安装硬件；d)电子燃料管理；e)加油容器。应认识到，可以检查本文未具体涵盖的各种组件以满足本文的标准，并根据适当的功能测试进行测试。除非另有说明，本文件中对压力的所有引用均被视为表压。本文件基于天然气作为燃料的工作压力为1.6 MPa【16 bar1】。通过以适当的系数（比率）调节压力，可以适应其他工作压力。例如，2 MPa（20 bar）工作压力系统将需要将压力乘以1.25。？11巴=0.1 MPa=105Pa；1MPa=1N/mm2。
This document specifies tests and requirements for the check valve, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833.
This document is not applicable to the following:
a) fuel containers;
b) stationary gas engines;
c) container mounting hardware;
d) electronic fuel management;
e) refuelling receptacles.
It is recognized that miscellaneous components not specifically covered herein can be examined to meet the criteria of this document and tested according to the appropriate functional tests.
All references to pressure in this document are to be considered gauge pressures unless otherwise specified.
This document is based upon a working pressure for natural gas as a fuel of 1,6 MPa [16 bar1]. Other working pressures can be accommodated by adjusting the pressure by the appropriate factor (ratio). For example, 2 MPa (20 bar) working pressure system will require pressures to be multiplied by 1,25.
1 1 bar = 0,1 MPa = 105 Pa; 1 MPa = 1 N/mm2.
标准预览图
