ISO 6185-3:2024 充气艇 第3部分：发动机额定功率为15kW及以上、船身长度小于8m的艇
标准编号：ISO 6185-3:2024
中文名称：充气艇 第3部分：发动机额定功率为15kW及以上、船身长度小于8m的艇
英文名称：Inflatable boats — Part 3: Boats with a length of the hull less than 8 m with a motor power rating of 15 kW and greater
发布日期：2024-04
标准范围
本文件规定了充气艇和船体长度为LH的刚性充气艇的设计、材料、制造和试验所需的最低安全特性，符合ISO？8666小于8？电机额定功率为15？千瓦及更大。本文件适用于工作温度为-20？°C到+60？C:—？VII型:动力艇，在左舷和右舷装有浮力管，适合在C类和D类设计条件下航行。—？VIII型:动力艇，在左舷和右舷装有浮力管，适合在B类设计条件下航行。本文件不包括单室船和带有由无支撑材料制成的管子的船，也不适用于水上玩具和充气救生筏。本文件不包括带有由铝、滚塑聚乙烯、纤维增强塑料或其他刚性材料制成的管子的船只。
This document specifies the minimum safety characteristics required for the design, materials, manufacture and testing of inflatable boats and rigid inflatable boats with a length of the hull LH in accordance with ISO 8666 less than 8 m with a motor power rating of 15 kW and greater.
This document is applicable to the following types of boats intended for use within the operating temperatures of –20 °C to +60 °C:
— Type VII: Powered boats, fitted with a buoyancy tube on the port and starboard sides, suitable for navigation in conditions of design categories C and D.
— Type VIII: Powered boats, fitted with a buoyancy tube on the port and starboard sides, suitable for navigation in conditions of design category B.
This document excludes single-chambered boats and boats with tubes made from unsupported materials, and does not apply to aquatic toys and inflatable liferafts.
Boats with tubes made from aluminium, roto-moulded polyethylene, fibre reinforced plastic or other rigid materials are excluded from this document.
标准预览图
