ISO 8178-10:2002 往复内燃机-废气排放测量-第10部分：瞬变状态下压缩点火机废气排放现场测量试验周期和试验程序

标准编号：ISO 8178-10:2002

中文名称：往复内燃机-废气排放测量-第10部分：瞬变状态下压缩点火机废气排放现场测量试验周期和试验程序

英文名称：Reciprocating internal combustion engines — Exhaust emission measurement — Part 10: Test cycles and test procedures for field measurement of exhaust gas smoke emissions from compression ignition engin

发布日期：2002-11

标准范围

ISO 8178-10规定了在现场条件下评估压燃式发动机烟雾排放的测量程序和试验循环。它主要用于支持已根据ISO 8178-9规定“认证”或“型式认证”的发动机上的在用烟雾测试程序。对于瞬态烟雾试验循环，烟雾试验使用基于消光原理的烟雾计进行。ISO 8178本部分的目的是定义烟雾试验循环以及用于测量和分析烟雾的方法。ISO 8178本部分中描述的试验程序和测量技术一般适用于往复式内燃机（RIC）。然而，只有在制定了适当的试验循环后，才能使用ISO 8178的本部分对发动机应用进行评估。

ISO 8178-10 specifies the measurement procedures and test cycles for the evaluation of smoke emissions from compression ignition engines under field conditions. It is intended for use primarily as a support for in-use smoke testing programmes on engines that have been "certified" or "type approved" in accordance with the provisions of ISO 8178-9.For transient smoke test cycles, smoke testing is conducted using smokemeters that operate on the light extinction principle. The purpose of this part of ISO 8178 is to define the smoke test cycles and the methods used to measure and analyse smoke. The test procedures and measurement techniques described in this part of ISO 8178 are applicable to reciprocating internal combustion (RIC) engines in general. However, an engine application can only be evaluated using this part of ISO 8178 once the appropriate test cycle has been developed.

标准预览图