ISO 2137:2007 石油产品和润滑剂 润滑脂和矿脂的锥入度测定

标准编号：ISO 2137:2007

中文名称：石油产品和润滑剂 润滑脂和矿脂的锥入度测定

英文名称：Petroleum products and lubricants — Determination of cone penetration of lubricating greases and petrolatum

发布日期：2007-12

标准范围

ISO 2137:2007规定了几种通过测量标准锥的贯入度经验估算润滑脂和矿脂稠度的方法。规定了四种程序，用于通过测量未加工、已加工、长时间加工和块体贯穿件的全尺寸圆锥贯穿件的贯穿件来确定润滑脂的稠度，贯穿件最多可达500个单位。ISO 2137:2007规定了当只有小样本可用时，通过使用半锥来确定润滑脂稠度的方法-所列方法的刻度或四分之一刻度，适用于使用满刻度锥的穿透度为175单位至385单位的润滑脂。

ISO 2137:2007 specifies several methods for the empirical estimation of the consistency of lubricating greases and petrolatum by measuring the penetration of a standardized cone. Four procedures are specified for determining the consistency of lubricating greases by measuring the penetration of a full-scale cone for unworked, worked, prolonged worked and block penetrations for penetrations of up to 500 units.ISO 2137:2007 specifies methods for determining the consistency of lubricating greases when only small samples are available, by the use of cones a half-scale or quarter-scale for the listed methods, applicable to greases having penetrations of 175 units to 385 units using the full-scale cone.

标准预览图