ISO 23153-2:2020 塑料 聚醚醚酮模塑和挤出材料 第2部分：试样的制备和性能的测定

标准编号：ISO 23153-2:2020

中文名称：塑料 聚醚醚酮模塑和挤出材料 第2部分：试样的制备和性能的测定

英文名称：Plastics — Polyetheretherketone (PEEK) moulding and extrusion materials — Part 2: Preparation of test specimens and determination of properties

发布日期：2020-01

标准范围

本文件规定了试样的制备方法，以及用于测定聚醚醚酮（PEEK）模塑和挤出材料性能的试验方法。给出了处理试验材料的要求，以及成型前试验材料和试验前试样的调节要求。还给出了制备试样的程序和条件，以及测量制备试样所用材料性能的程序。列出了表征PEEK模塑和挤出材料的合适和必要的性能和试验方法。为了获得可重复和可比较的试验结果，使用本文规定的制备和调节方法、试样尺寸和试验程序。确定的值不一定与使用不同尺寸的试样或使用不同程序制备的试样获得的值相同。

This document specifies the methods of preparation of test specimens and the test methods to be used in determining the properties of polyetheretherketone (PEEK) moulding and extrusion materials. Requirements for handling test material and for conditioning both the test material before moulding and the specimens before testing are given.Procedures and conditions for the preparation of test specimens and procedures for measuring properties of the materials from which these specimens are made are also given. Properties and test methods that are suitable and necessary to characterize PEEK moulding and extrusion materials are listed.In order to obtain reproducible and comparable test results, the methods of preparation and conditioning, the specimen dimensions and the test procedures specified herein are used. Values determined will not necessarily be identical to those obtained using specimens of different dimensions or prepared using different procedures.

标准预览图