ISO 12164-4:2023 带有法兰接触面的空心圆锥接口 第4部分：T、TA和U型空心锥柄用T和U型安装孔

标准编号：ISO 12164-4:2023

中文名称：带有法兰接触面的空心圆锥接口 第4部分：T、TA和U型空心锥柄用T和U型安装孔

英文名称：Hollow taper interface with flange contact surface — Part 4: Receivers of types T and U for hollow taper shanks of types T, TA and U

发布日期：2023-10

标准范围

本文件根据ISO 12164-3规定了适用于机床（车床以及车床和铣床的组合）的空心锥形柄（HSK）的锥形和法兰接触面接收器的尺寸。本文档指定了两种类型的接收器:-自动换刀的T型；-U型仅用于手动换刀，通过接收器和刀柄上的径向孔。注1:T型和U型接收器适合HSK柄T、TA和U（根据ISO 12164-3）。根据ISO 12164-1，接收器还适合HSK柄A、AB、C和CB。注2 HSK类型A、AB、C、CB、T和TA也可以手动更改。

This document specifies dimensions for receivers with taper and flange contact surfaces for hollow taper shanks (HSK) according to ISO 12164-3 to be applied to machine tools (turning and combinations of turning and milling machines).

This document specifies two types of receivers:

—     type T for automatic tool change;

—     type U for manual tool change only, via radial holes in both the receiver and the tool shank.

NOTE 1        The receivers of types T and U fit the HSK shanks T, TA and U (according to ISO 12164-3). The receivers also fit the HSK shanks A, AB, C and CB according to ISO 12164-1.

NOTE 2        HSK types A, AB, C, CB, T and TA can also be changed manually.

标准预览图