ISO 12917-1:2017 石油和液体石油产品 水平圆柱罐刻度 第1部分：手工方法

标准编号：ISO 12917-1:2017

中文名称：石油和液体石油产品 水平圆柱罐刻度 第1部分：手工方法

英文名称：Petroleum and liquid petroleum products — Calibration of horizontal cylindrical tanks — Part 1: Manual methods

发布日期：2017-03

标准范围

ISO 12917-1:2017规定了安装在固定位置的标称水平圆柱形储罐的手动校准方法。本文件中的方法适用于地面或地下的绝缘和非绝缘储罐。该方法适用于带压储罐、转向节碟形端和平端圆柱形储罐以及椭圆形和球形封头储罐。ISO 12917-1:2017适用于从水平面倾斜的储罐，前提是对测量的倾斜进行了校正。尽管本文件未对本文件适用的最大储罐直径和最大储罐倾斜施加任何限制，但实际限制为直径约4 m，倾斜约10°。

ISO 12917-1:2017 specifies manual methods for the calibration of nominally horizontal cylindrical tanks, installed at fixed locations.The methods in this document are applicable to insulated and non-insulated tanks, either when they are above-ground or underground. The methods are applicable to pressurized tanks and to both knuckle-dish-end and flat-end cylindrical tanks as well as elliptical and spherical head tanks.ISO 12917-1:2017 is applicable to tanks inclined from the horizontal, provided a correction is applied for the measured tilt.Although this document does not impose any limits on the maximum tank diameter and maximum tank tilt to which this document is applicable, the practical limits would be about 4 m in diameter and 10° in tilt.

标准预览图