ISO 12714:1999 无损检验-声频传播检查-二级声频探测器校准.

标准编号：ISO 12714:1999

中文名称：无损检验-声频传播检查-二级声频探测器校准.

英文名称：Non-destructive testing — Acoustic emission inspection — Secondary calibration of acoustic emission sensors

发布日期：1999-07

标准范围

本国际标准规定了声发射传感器的二次校准方法固体介质表面的弹性波接收器。国际标准适用于实验室三级标准传感器和声发射应用传感器。二次校准会产生传感器对通常在工作中遇到的波的频率响应声发射功，即瑞利波。产生用于校准的信号的源是安装在与被测传感器（SUT）相同的试块表面上。传感器的灵敏度为在100 kHz到1 MHz的范围内确定激励。灵敏度值通常在频率相隔约10千赫。校准单位为每单位机械输入的伏特（位移、速度或加速度）。

This International Standard specifies a method for the secondary calibration of acoustic emission sensors asreceivers of elastic waves at the surface of a solid medium. The International Standard is applicable to laboratorytertiary standard sensors and acoustic emission applications sensors.The secondary calibration yields the frequency response of a sensor to waves of a type normally encountered inacoustic emission work, namely Rayleigh waves. The source producing the signal used for the calibration ismounted on the same surface of a test block as the sensor under test (SUT). The sensitivity of the sensor isdetermined for excitation within the range of 100 kHz to 1 MHz. Sensitivity values are usually determined atfrequencies approximately 10 kHz apart. The units of the calibration are volts per unit of mechanical input(displacement, velocity or acceleration).

标准预览图