ISO 10684:2004 紧固件 热浸镀锌层

标准编号：ISO 10684:2004

中文名称：紧固件 热浸镀锌层

英文名称：Fasteners — Hot dip galvanized coatings

发布日期：2004-07

标准范围

ISO 10684:2004规定了适用于M8至M64粗螺纹钢紧固件的热浸镀锌涂层的材料、工艺、尺寸和一些性能要求，以及适用于螺栓、螺钉和螺柱的10.9级和螺母的12级以下性能要求。不建议对直径小于M8和/或节距小于1.25 mm的螺纹紧固件进行热浸镀锌。ISO 10684:2004主要涉及螺纹钢紧固件的旋压热浸镀锌，但也可应用于其他螺纹钢零件。本文件中给出的规范也可适用于非-螺纹钢零件，如垫圈。

ISO 10684:2004 specifies material, process, dimensional and some performance requirements for hot dip spun galvanized coatings applied to coarse threaded steel fasteners from M8 up to and including M64 and for property classes up to and including 10.9 for bolts, screws and studs and 12 for nuts. It is not recommended to hot dip galvanize threaded fasteners in diameters smaller than M8 and/or with pitches below 1,25 mm.ISO 10684:2004 primarily concerns the spun hot dip galvanizing of threaded steel fasteners, but it may also be applied to other threaded steel parts. The specifications given in this document may also be applied to non-threaded steel parts such as washers.

标准预览图