ISO 8662-11:1999 手提式电动工具 手柄振动测量 第11部分：打钉器

标准编号：ISO 8662-11:1999

中文名称：手提式电动工具 手柄振动测量 第11部分：打钉器

英文名称：Hand-held portable power tools — Measurement of vibrations at the handle — Part 11: Fastener driving tools

发布日期：1999-06

标准范围

ISO 8662的这一部分规定了一种实验室方法，用于测量手柄处的单次振动紧固件驱动工具，其中单个事件是机械冲击或间隔较长的一系列单独冲击大于0.2 s。这是一种用于确定手持式电动工具手柄振动值的型式试验程序在特定负载下运行。注:紧固件驱动工具也称为钉钉器、钉钉器、钉钉器和订书机。对于ISO 8662本部分适用的紧固件驱动工具，操作所需的功率可为由气动或液压、内燃机中的可燃气体或弹簧提供紧张紧固件驱动工具可通过单驱动、接触驱动或连续驱动进行驱动。ISO 8662的本部分适用于由钉子、订书钉、销钉、波纹紧固件和所用螺钉组成的紧固件用作钉子、销钉、套管、电缆环和底座支架。ISO 8662本部分的应用结果旨在用于比较同样类型的电动工具。

This part of ISO 8662 specifies a laboratory method for measuring the single-event vibration at the handle offastener driving tools, where a single event is a mechanical shock or a series of individual shocks at intervals longerthan 0,2 s. It is a type test procedure for establishing the vibration value in the handle of a hand-held power tooloperating under a specified load.NOTE Fastener driving tools are also referred to as nailers, pinners, tackers and staplers.For fastener driving tools to which this part of ISO 8662 is applicable, the power required for operation can besupplied by pneumatic or hydraulic pressure, combustible gases in an internal combustion engine or from springtension. The fastener driving tools may be actuated by single actuation, contact actuation or continuous actuation.This part of ISO 8662 is applicable to fasteners comprising nails, staples, pins, corrugated fasteners, screws usedas nails, dowels, sleeves, cable collars and base supports.It is intended that the results of application of this part of ISO 8662 be used for comparing different models of thesame type of power tool.

标准预览图