ISO 10897:2016 工具柄用1：10锥柄的弹簧夹头 弹簧夹头、锥柄座、螺母

标准编号：ISO 10897:2016

中文名称：工具柄用1：10锥柄的弹簧夹头 弹簧夹头、锥柄座、螺母

英文名称：Collets for tool holders with taper ratio 1:10 — Collets, holders, nuts

发布日期：2016-09

标准范围

ISO 10897:2016规定了圆柱柄工具及其相应支架和螺母的尺寸、材料和制造要求，以及夹头的名称。对于非标准化夹紧装置，如图纸中规定的夹紧装置，客户和供应商可就这些支架达成一致。表A适用于夹紧范围为H10的情况。表格B可用于无横向切削载荷的任何应用。附录A规定了AT3公差和AT4公差的值。

ISO 10897:2016 specifies the dimensions, materials and manufacturing requirements, and designation of collets for tools with cylindrical shanks and their corresponding holders and nuts. For non-standardized clamping devices, such as clamping devices specified in drawings, these holders can be agreed upon between customer and supplier.Form A applies where a clamping range of H10 is sufficient.Form B can be used for any application without lateral cutting load.Annex A specifies the values for AT3 tolerance and AT4 tolerance.

标准预览图