ISO 8007-2:1999 炼铝用碳质材料-取样计划和从个体单位中取样-第二部分：预锻烧阳极坯.

标准编号：ISO 8007-2:1999

中文名称：炼铝用碳质材料-取样计划和从个体单位中取样-第二部分：预锻烧阳极坯.

英文名称：Carbonaceous materials used in the production of aluminium — Sampling plans and sampling from individual units — Part 2: Prebaked anodes

发布日期：1999-08

标准范围

ISO 8007的本部分规定了预焙阳极取样计划的创建和执行程序从一大批货物或一批货物中。注:如果需要，术语“批次”可替换为术语“批次”。ISO 8007的这一部分还规定了从单个阳极上取样的首选位置。阴极块和预焙阳极是分开考虑的。阴极块取样程序如下:在ISO 8007-1中给出。有关安全方面的建议，读者可参考ISO 3165:1976《工业用化学产品的取样》-取样的安全性。

This part of ISO 8007 specifies procedures for the creation and execution of a sampling plan for prebaked anodesfrom a large consignment or from a batch.NOTE The term "batch" can be substituted by the term "lot" if desired.This part of ISO 8007 also specifies the preferred locations for taking test samples from individual anodes.Cathode blocks and prebaked anodes are considered separately. Procedures for sampling cathode blocks aregiven in ISO 8007-1.For advice on safety, the reader is referred to ISO 3165:1976, Sampling of chemical products for industrial use —Safety in sampling.

标准预览图