ISO 6789-1:2017 螺钉和螺母总装工具 手动转矩工具 第1部分：设计一致性和质量一致性测试的要求和方法：一致性的最低要求

标准编号：ISO 6789-1:2017

中文名称：螺钉和螺母总装工具 手动转矩工具 第1部分：设计一致性和质量一致性测试的要求和方法：一致性的最低要求

英文名称：Assembly tools for screws and nuts — Hand torque tools — Part 1: Requirements and methods for design conformance testing and quality conformance testing: minimum requirements for declaration of confor

发布日期：2017-02

标准范围

ISO 6789-1:2017规定了用于受控拧紧螺钉和螺母的手动扭矩工具的一致性测试和标记要求。它还规定了手动扭矩工具合规性声明的最低要求。ISO 6789-1:2017适用于手动扭矩工具，分为指示扭矩工具（I型）和设定扭矩工具（II型）。注:本文件涵盖的手动扭矩工具是ISO 1703:2005中通过参考号6100 11 0、6100 11 1和6100 12 0、6100 12 1和6100 14 0、6100 15 0识别的工具。ISO 1703目前正在修订中。在下一版本中，扭矩工具将被移动到一个单独的条款中，随着这一更改，参考号也将更改，并添加其他参考号。ISO 6789-1:2017未规定手动扭矩工具的校准证书要求。这些在ISO 6789-2中有描述。

ISO 6789-1:2017 specifies the conformance testing and marking requirements for hand torque tools used for controlled tightening of screws and nuts. It also specifies the minimum requirements for declaration of conformance for hand torque tools.ISO 6789-1:2017 applies to hand torque tools which are classified as indicating torque tools (Type I) and setting torque tools (Type II).NOTE Hand torque tools covered by this document are those identified in ISO 1703:2005 by reference numbers 6 1 00 11 0, 6 1 00 11 1 and 6 1 00 12 0, 6 1 00 12 1 and 6 1 00 14 0, 6 1 00 15 0. ISO 1703 is currently under revision. In the next edition, torque tools will be moved to an own clause, and with this change the reference numbers will also change and additional reference numbers will be added.ISO 6789-1:2017 does not specify requirements of calibration certificates for hand torque tools. These are described in ISO 6789？2.

标准预览图