ISO 3269:2019 紧固件 验收检查

标准编号：ISO 3269:2019

中文名称：紧固件 验收检查

英文名称：Fasteners — Acceptance inspection

发布日期：2019-07

标准范围

本文件规定了买方在没有事先协议的情况下使用的检验程序。它还规定了一个参考验收程序，用于验收或拒收检验批，当买方和供应商之间无法达成协议时，或在与规范的一致性存在争议时。适用于螺栓、螺钉、螺柱、螺母、销、垫圈、铆钉及其他相关紧固件的检验批。本文件适用于不适用于大批量机器组装、特殊用途应用或需要更先进技术的特殊工程应用的紧固件-过程控制和批次可追溯性。关于制造和分拣的过程控制或最终检验，请参见ISO 16426。

This document specifies an inspection procedure to be used by the purchaser where no prior agreement exists.It also specifies a reference acceptance procedure for acceptance or rejection of an inspection lot, when no agreement can be reached between the purchaser and the supplier, or where conformance to specification is disputed.It applies to inspection lots of bolts, screws, studs, nuts, pins, washers, rivets and other related fasteners.This document applies to fasteners not intended for high volume machine assembly, special-purpose applications or specially engineered applications requiring more advanced in-process control and lot traceability.For in-process control or final inspection by the manufacture and sorting, see ISO 16426.

标准预览图