ISO 17190-11:2001 失禁病人吸尿器械 聚合体试验方法-第11部分：可呼吸颗粒容量测定

标准编号：ISO 17190-11:2001

中文名称：失禁病人吸尿器械 聚合体试验方法-第11部分：可呼吸颗粒容量测定

英文名称：Urine-absorbing aids for incontinence — Test methods for characterizing polymer-based absorbent materials — Part 11: Determination of content of respirable particles

发布日期：2001-12

标准范围

ISO 17190的本部分规定了测定聚丙烯酸酯（PA）中可吸入颗粒物含量的方法高吸水性粉末。注:商用聚丙烯酸酯高吸水性粉末由平均直径为400μm至800μm的颗粒组成，远大于大约10μm可吸入颗粒物的最大尺寸。由于生产过程，商用高吸水性粉末中可能存在极少量的可吸入颗粒。

This part of ISO 17190 specifies a method for determining the content of respirable particles in polyacrylate (PA)superabsorbent powders.NOTE Commercial polyacrylate superabsorbent powders consist of particles averaging 400 μm to 800 μm in diameter,which are much larger than the maximum size for respirable particles of approximately 10 μm. Due to the production process,very low amounts of respirable particles may be present in commercial superabsorbent powders.

标准预览图