ISO 5600:2007 橡胶 用锥形件测定与刚性材料的粘合强度

标准编号：ISO 5600:2007

中文名称：橡胶 用锥形件测定与刚性材料的粘合强度

英文名称：Rubber — Determination of adhesion to rigid materials using conical shaped parts

发布日期：2007-07

标准范围

ISO 5600:2007规定了测定橡胶化合物与刚性材料静态硫化粘合强度的方法。试件由刚性材料的两个锥形端组成，由一个橡胶圆筒连接。通过粘结系统获得附着力，粘结系统不仅包括刚性材料和橡胶化合物，还包括其他元素，如薄合金涂层或刚性零件的化学处理，以及单一水泥或底漆和覆盖水泥。用户应充分指定用于制备试样的粘接系统，但本国际标准中规定了与复杂粘接系统相关的不同类型故障的评估。该方法主要用于实验室在标准条件下制备的试样，以便为粘结系统及其组件（如水泥或特殊橡胶化合物）的开发和控制以及制造方法提供数据。虽然拟用于橡胶粘合到刚性支撑件上的情况，但可能不包括支撑件（虽然是高模量材料）由于横向尺寸较小而具有低刚性的情况，如橡胶粘合到金属丝、绳索或薄板上的情况。

ISO 5600:2007 specifies a method for the determination of the static vulcanized adhesion strength of rubber compounds to rigid materials. The test piece is composed of two conical ends of the rigid material, joined by a cylinder of rubber.The adhesion is obtained by a bonding system which can include not only the rigid material and the rubber compound, but other elements such as thin alloy coatings or chemical treatments of rigid parts and either a single cement or both primer and cover cements. The bonding system for preparing the test pieces should be adequately specified by the user, but provision is made in this International Standard for the evaluation of different types of failure related to a complex bonding system.The method is designed primarily for test pieces prepared in the laboratory under standard conditions in order to provide data for development and control of bonding systems and their components, such as cements or special rubber compounds, and of methods of manufacture. While intended to be applied where the rubber is bonded to rigid supporting pieces, it might not cover such cases where the support, although of high-modulus material, has a low rigidity due to small transverse dimensions, as in the case of rubber bonded to metal wires, cords or thin sheets.

标准预览图