ISO 12151-2:2003 液压机液体连接和一般使用-第2部分：ISO 8434-1和ISO 8434-4 24°O环锥形连接器端头的软管装置

标准编号：ISO 12151-2:2003

中文名称：液压机液体连接和一般使用-第2部分：ISO 8434-1和ISO 8434-4 24°O环锥形连接器端头的软管装置

英文名称：Connections for hydraulic fluid power and general use — Hose fittings — Part 2: Hose fittings with ISO 8434-1 and ISO 8434-4 24 degree cone connector ends with O-rings

发布日期：2003-06

标准范围

根据ISO 8434-1和ISO 8434-4，ISO 12151-2:2003规定了带O形圈的24°锥形接头软管接头设计和性能的一般要求和尺寸要求。这些软管接头由碳钢制成，用于标称内径为5 mm至38 mm（含）的软管。这些软管接头用于流体动力系统中，软管符合相应标准的要求，并在一般应用中使用合适的软管。

ISO 12151-2:2003 specifies the general and dimensional requirements for the design and performance of hose fittings with 24° cone connector ends with O-rings, in accordance with ISO 8434-1 and ISO 8434-4. These hose fittings are made of carbon steel and are intended for use with hoses with nominal inside diameters from 5 mm through 38 mm (inclusive).These hose fittings are for use in fluid power systems with hoses that meet the requirements of respective standards and in general applications with suitable hoses.

标准预览图