ISO 8533:2003 玻璃增强热硬化塑料管道和配件-接合或包裹接点设计试验方法

标准编号：ISO 8533:2003

中文名称：玻璃增强热硬化塑料管道和配件-接合或包裹接点设计试验方法

英文名称：Plastics piping systems for pressure and non-pressure drainage and sewerage — Glass-reinforced thermosetting plastics (GRP) systems based on unsaturated polyester (UP) resin — Test methods to prove th

发布日期：2003-12

标准范围

ISO 8533:2003规定了埋地和非埋地管道用玻璃纤维增强热固性塑料（GRP）塑料管道系统的胶结或包裹接头的试验方法。本标准仅适用于接头，包括证明其设计的试验方法。它假设接头可能会或不会受到静水压端推力的影响。本试验适用于拟用于埋地或非埋地应用的胶结或包裹接头。弯曲试验可用于证明接头拟用于埋地应用或拟用于试验可能被认为合适的特定地上情况下的设计。除弯曲试验外，这些试验程序适用于所有标称尺寸的管道和管件之间的接头。弯曲试验适用于DN 600及以下的管道和管件之间的接头。这些试验适用于在参考标准中规定的温度下对用于输送液体的接头进行评估。

ISO 8533:2003 specifies methods of test for cemented or wrapped joints for plastics piping systems made of glass-reinforced thermosetting plastics (GRP) for buried and non-buried pipelines. This standard is only applicable to the joint and covers methods of test to prove its design. It assumes that the joint either is or is not intended to be subject to the effects of hydrostatic end thrust.The tests are applicable to cemented or wrapped joints intended to be used in either buried or non-buried applications. The bending tests can be used to prove the design where joints are either intended to be used in buried applications or are intended to be used in particular above-ground situations where the tests may be considered appropriate.With the exception of the bending tests, these test procedures are applicable to joints between pipes and fittings of all nominal sizes. The bending tests are applicable to joints between pipes and fittings up to and including DN 600. The tests are applicable to the evaluation of joints intended for the conveyance of liquids at temperatures specified in the referring standards.

标准预览图