ISO 8289-1:2020 玻璃和搪瓷 检测和定位缺陷的低压试验 第1部分：非仿形表面的拭子试验

标准编号：ISO 8289-1:2020

中文名称：玻璃和搪瓷 检测和定位缺陷的低压试验 第1部分：非仿形表面的拭子试验

英文名称：Vitreous and porcelain enamels — Low-voltage test for detecting and locating defects — Part 1: Swab test for non-profiled surfaces

发布日期：2020-02

标准范围

本文件规定了两种低电压试验，用于检测和定位玻璃和搪瓷涂层中延伸至基底金属的缺陷。方法A（电气）适用于快速检测和确定缺陷的一般位置。基于颜色效果的方法B（光学）适用于更精确地检测缺陷及其确切位置。这两种方法通常适用于平面。对于更复杂的形状，如波状和/或波纹表面，ISO 8289-2适用。注1:选择正确的测试方法对于区分方法B检测到的电导率增加区域与延伸至基体金属的实际孔隙（这两种方法都可以检测到）至关重要。注2:低压试验是一种无损检测缺陷的方法，因此与ISO 2746中规定的高压试验完全不同。高电压和低电压测试的结果不可比较，并且会有所不同。

This document specifies two low voltage tests for detecting and locating defects that extend to the basis metal in vitreous and porcelain enamel coatings.Method A (electrical) is applicable to the rapid detection and determination of the general location of defects. Method B (optical), based on colour effects, is applicable to the more precise detection of defects and their exact locations. Both methods are commonly applied to flat surfaces. For more intricate shapes, such as undulated and/or corrugated surfaces, ISO 8289-2 is applicable.NOTE 1 Selection of the correct test method is critical to distinguish the areas of increased conductivity detected by method B from actual pores that extend to the basis metal, which can be detected by both methods.NOTE 2 The low voltage test is a non-destructive method of detecting defects and, therefore, is completely different from the high voltage test specified in ISO 2746. The results of the high and low voltage tests are not comparable and will differ.

标准预览图