ISO 6806:2024 用于油燃烧器的橡胶软管和软管组合件 规范

标准编号：ISO 6806:2024

中文名称：用于油燃烧器的橡胶软管和软管组合件 规范

英文名称：Rubber hoses and hose assemblies for use in oil burners — Specification

发布日期：2024-05

标准范围

本文件规定了燃油燃烧器中使用的橡胶软管和软管组件的最低要求。规定了以下两种类型的软管组件:—？类型1:用于流量和回流的软管组件，但不用于插入燃油燃烧器泵和雾化连接之间；最大工作压力1,0？A(10？吧);最高油温100？°C；—？类型2:用于插入燃油燃烧器泵和雾化连接件之间的软管组件；最大工作压力4,0？A(40？栏);最高油温100？°C。未经特殊评估，本文件中规定的软管组件不得用于燃油燃烧器安装以外的其他目的。

This document specifies the minimum requirements for rubber hoses and hose assemblies for use in oil burners.

The following two types of hose assembly are specified:

—     Type 1: Hose assemblies for flux and reflux, but not for insertion between the oil burner pump and the atomizing connection; maximum working pressure 1,0 MPa (10 bar); maximum oil temperature 100 °C;

—     Type 2: Hose assemblies for insertion between the oil burner pump and the atomizing connection; maximum working pressure 4,0 MPa (40 bar); maximum oil temperature 100 °C.

The hose assemblies specified in this document are not intended to be used, without special assessment, for purposes other than oil burner installations.

标准预览图