ISO 6807:2003 用于旋转式钻探和振动的橡胶软管和软管组件.规范

标准编号：ISO 6807:2003

中文名称：用于旋转式钻探和振动的橡胶软管和软管组件.规范

英文名称：Rubber hoses and hose assemblies for rotary drilling and vibration applications — Specification

发布日期：2003-12

标准范围

ISO 6807:2003规定了用于水基和/或油基泥浆的织物和钢增强橡胶软管及软管组件的要求，最高温度为82°C，在旋转钻井服务中以高压大量泵送，当按照ISO 2977进行测试时，其最低苯胺点为66°C。本国际标准适用于适合在-20°C至+52°C环境温度下使用的软管，除非根据买方要求的补充要求进行更改，并且耐老化和热带条件。本国际标准不适用于与气体一起使用的软管。

ISO 6807:2003 specifies the requirements for textile- and steel-reinforced rubber hoses and hose assemblies for use with water-based and/or oil-based muds, up to a maximum temperature of 82 °C, which are pumped at high pressure in large volumes in rotary drilling service and which, when tested in accordance with ISO 2977, have a minimum aniline point of 66 °C.This International Standard applies to hoses which are suitable for use at ambient temperatures between -20 °C and +52 °C, unless changed by a supplementary requirement on request of the purchaser, and are resistant to ageing and tropical conditions.This International Standard does not apply to hoses which are intended for use with gases.

标准预览图