ISO 10350-1:2007 塑料 参照性单点数据的采集和表示 第1部分：模塑材料

标准编号：ISO 10350-1:2007

中文名称：塑料 参照性单点数据的采集和表示 第1部分：模塑材料

英文名称：Plastics — Acquisition and presentation of comparable single-point data — Part 1: Moulding materials

发布日期：2007-07

标准范围

ISO 10350确定了获取和呈现塑料某些基本性能可比数据的具体试验程序。一般来说，每个特性由一个单独的试验值指定，尽管在某些情况下，特性由在不同试验条件下获得的两个值表示。所包含的特性是制造商数据表中常规显示的特性。ISO 10350-1:2007主要适用于未增强和增强的热塑性和热固性材料，这些材料可能是注射成型或压缩成型的，或制备成规定厚度的板材。ISO 10350的第2部分专门讨论了长期或持续的-纤维增强塑料。就ISO 10350而言，长纤维增强塑料在成型前的纤维长度应大于7.5 mm。

ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets.ISO 10350-1:2007 applies predominantly to unreinforced and reinforced thermoplastic and thermosetting materials that may be injection- or compression-moulded or prepared as sheets of specified thickness. Part 2 of ISO 10350 deals specifically with long- or continuous-fibre-reinforced plastics. For the purposes of ISO 10350, long-fibre-reinforced plastics are considered to have fibre lengths greater than 7,5 mm prior to moulding.

标准预览图