ISO 3547-2:2017 滑动轴承 卷制轴套 第2部分：外径和内径的测试数据

标准编号：ISO 3547-2:2017

中文名称：滑动轴承 卷制轴套 第2部分：外径和内径的测试数据

英文名称：Plain bearings — Wrapped bushes — Part 2: Test data for outside and inside diameters

发布日期：2017-02

标准范围

ISO 3547-2:2017规定了滑动轴承用单层和多层轴承材料制成的缠绕衬套的外径和内径的试验数据。它还规定了测试名称。由于衬套的壁厚是在自由状态下测量的，因此图纸上不需要特殊的试验数据（参见ISO 3547-5和ISO 3547-6）。注:根据制造方法的不同，衬套背面可能会出现孤立的轻微凹陷，同样，带有润滑孔、凹槽和孔凹痕的衬套也可能会出现变形。因此，建议在远离这些区域的地方测量壁厚。

ISO 3547-2:2017 specifies the test data for outside and inside diameters of wrapped bushes made of mono and multi-layer bearing material for plain bearing applications. It also specifies test designations.Since the wall thickness of the bush is measured in the free condition, no special test data are required for this on the drawing (see ISO 3547？5 and ISO 3547？6).NOTE Depending on the manufacturing method, the back of the bushes can show isolated light depressions and, similarly, bushes with lubrication holes, grooves and bore indentations can show distortion. It is therefore suggested to measure the wall thickness away from these areas.

标准预览图