ISO/IEC TR 29158:2011 信息技术 自动识别和数据采集技术 直接部件打标（DPM）质量指南

标准编号：ISO/IEC TR 29158:2011

中文名称：信息技术 自动识别和数据采集技术 直接部件打标（DPM）质量指南

英文名称：Information technology — Automatic identification and data capture techniques — Direct Part Mark (DPM) Quality Guideline

发布日期：2011-10

标准范围

ISO/IEC TR 29158:2011是一份面向验证器制造商和应用规范开发人员的工程文件。它描述了要结合ISO/IEC 15415中定义的符号质量方法和符号系统规范来考虑的修改。它定义了替代照明条件、一些新术语和参数、对某些参数的测量和分级的修改以及分级结果的报告。ISO/IEC TR 29158:2011旨在评估直接标记零件的符号质量，其中标记直接应用于物品表面，读取设备是二维成像仪。在应用规范允许的情况下，该方法也可以应用于其他方法产生的符号。当在同一扫描环境中扫描直接零件标记(DPM)符号和非DPM符号时，这是合适的。符号等级报告为DPM等级，而不是ISO/IEC 15415等级。

ISO/IEC TR 29158:2011 is an engineering document intended for verifier manufacturers and application specification developers.

It describes modifications which are to be considered in conjunction with the symbol quality methodology defined in ISO/IEC 15415 and a symbology specification. It defines alternative illumination conditions, some new terms and parameters, modifications to the measurement and grading of certain parameters, and the reporting of the grading results.

ISO/IEC TR 29158:2011 was developed to assess the symbol quality of direct marked parts, where the mark is applied directly to the surface of the item and the reading device is a two-dimensional imager.

When application specifications allow, this method may also be applied to symbols produced by other methods. This is appropriate when direct part marked (DPM) symbols and non-DPM symbols are being scanned in the same scanning environment. The symbol grade is reported as a DPM grade rather than as an ISO/IEC 15415 grade.

标准预览图