ISO 15610:2024 金属材料焊接工艺规程及评定 基于试验焊接材料的工艺评定

标准编号：ISO 15610:2024

中文名称：金属材料焊接工艺规程及评定 基于试验焊接材料的工艺评定

英文名称：Specification and qualification of welding procedures for metallic materials — Qualification based on tested welding consumables

发布日期：2024-03

标准范围

本文件规定了如何通过使用测试的焊接耗材数据来鉴定焊接程序。它扩展了ISO 15607中给出的要求。此外，它给出了资格的范围。根据ISO/TR 15608，本文件的应用仅限于母体材料组1.1、8.1、21、22.1和22.2，其在热影响区产生可接受的微观结构和性能，在使用中不会显著恶化。本文件仅限于:—？厚度为t的材料的对接焊缝和角焊缝？≤？40？mm（第1.1组和第8.1组）和t？≤？20？mm(组21、22.1和22.2)；—？喉部厚度为a的角焊缝？≥？1？嗯。当焊接接头规定了以下任一项时，本文件不适用:A）？硬度；b）？冲击性能；c）？预热；d）？受控热输入；e）？道间温度；(f)？焊后热处理。本文件的使用也可能受到应用标准、规范或其他文件的限制。

This document specifies how a welding procedure can be qualified by using tested welding consumable data. It expands on the requirements given in ISO 15607.

In addition, it gives the range of qualification.

Application of this document is limited to parent material groups 1.1, 8.1, 21, 22.1 and 22.2 in accordance with ISO/TR 15608, which produce acceptable microstructures and properties in the heat-affected zone which do not deteriorate significantly in service.

This document is limited to:

—     butt welds and fillet welds in material of thicknesses t ≤ 40 mm (groups 1.1 and 8.1) and t ≤ 20 mm (groups 21, 22.1 and 22.2);

—     fillet welds with throat thickness a ≥ 1 mm.

This document is not applicable when any of the following is specified for the welded joint:

a)       hardness;

b)       impact properties;

c)        preheating;

d)       controlled heat input;

e)       interpass temperature;

f)         post-weld heat treatment.

The use of this document can also be restricted by an application standard, specification or other documents.

标准预览图