ISO 15610:2003 金属材料焊接程序规范和条件-试验焊接消耗品条件

标准编号：ISO 15610:2003

中文名称：金属材料焊接程序规范和条件-试验焊接消耗品条件

英文名称：Specification and qualification of welding procedures for metallic materials — Qualification based on tested welding consumables

发布日期：2003-10

标准范围

ISO 15610:2003提供了必要的信息，以解释ISO 15607中引用的关于基于测试耗材的焊接工艺评定的要求。此外，它给出了资格的范围。ISO 15610:2003适用于电弧焊和气焊，但如有规定，可接受其他熔焊工艺。它仅适用于在热影响区产生可接受微观结构和性能且在使用中不会显著退化的母材金属。本国际标准不适用于对硬度或冲击性能、预热、受控热输入、层间温度和焊后温度的要求-焊接接头规定了焊接热处理。ISO 15610.2003的使用也可能受到应用标准或规范的限制。

ISO 15610:2003 gives the necessary information to explain the requirements referenced in ISO 15607 concerning the qualification of welding procedures based on tested consumables. In addition, it gives the range of qualification.ISO 15610:2003 applies to arc and gas welding but other fusion welding processes may be accepted if specified.It is limited to application to parent metals that produce acceptable micro structures and properties in the heat affected zone and which do not deteriorate significantly in service.This International Standard is not applicable where requirements for hardness or impact properties, preheating, controlled heat input, interpass temperature and post-weld heat-treatment are specified for the welded joint.The use of ISO 15610.2003 may also be restricted by an application standard or a specification.

标准预览图