ISO 4190-2:2001 电梯装置-.第2部分：Ⅳ级电梯

标准编号：ISO 4190-2:2001

中文名称：电梯装置-.第2部分：Ⅳ级电梯

英文名称：Lift (US: Elevator) installation — Part 2: Class IV lifts

发布日期：2001-02

标准范围

ISO 4190的这一部分规定了允许安装IV级升降机的必要尺寸，如3.2.4、一般用于货物（货运）的运输。它处理电动和液压升降机。通常定义井（美国:井道）的水平尺寸通过入口和驱动器配置。它涵盖了带有水平或垂直电动滑动门的升降机[参见图1a)和1b)]。对于其他特性，应咨询制造商。ISO 4190的这一部分适用于新的升降机装置，其轿厢有一个或两个入口，安装在新大楼。在相关的情况下，它可以用作在现有建筑物中安装的基础。解决了两种类型的负载（每单位面积的负载）:A系列:载重符合EN 81-1或EN 81-2的乘客和货物（货运）升降机；B系列:仅供货物（货运）使用的升降机，在允许使用的国家/地区具有不同的楼层负载他们的安全密码。

This part of ISO 4190 specifies the necessary dimensions to permit the installation of Class IV lifts, as defined in3.2.4, generally used for the transport of goods (freight).It deals with electric and hydraulic lifts. The horizontal dimensions of the wells (US: hoistways) are generally definedby the entrance and drive configurations. It covers lifts with either horizontal or vertical power-operated sliding doors[see Figures 1 a) and 1 b)].For other characteristics, the manufacturers should be consulted.This part of ISO 4190 is applicable to new lift installations, with a car with one or two entrances, to be installed in anew building. Where relevant, it may be used as a basis for an installation in an existing building.Two types of loading (load per unit area) are addressed:Series A: passenger and goods (freight) lifts with loading conforming to EN 81-1 or EN 81-2;Series B: lifts for goods (freight) only, which have a different floor loading in countries which allow this by virtue oftheir safety codes.

标准预览图