ISO 4308-1:2003 起重机和提升设备.钢丝绳的选用.第1部分：总则
标准编号：ISO 4308-1:2003
中文名称：起重机和提升设备.钢丝绳的选用.第1部分：总则
英文名称：Cranes and lifting appliances — Selection of wire ropes — Part 1: General
发布日期：2003-05
标准范围
ISO 4308-1:20 03规定了两种选择在ISO 4306-1中指定的起重设备上使用的钢丝绳的方法，一种基于绳索选择系数C的值，另一种基于利用系数Zp的值。ISO 4308-1:20 03规定了关于起重设备的设计、应用和维护的钢丝绳的可接受强度和性能水平的最低要求。ISO 4308-1:20 03规定了与所选钢丝绳相关的滚筒和滑轮直径的最低要求。附录A给出了ISO 4308-1:20 03适用的起重设备类型的非详尽列表。附录B提供了一些绳索选择的例子。附录C给出了除上述因素外，选择钢丝绳时可能需要考虑的因素。附录D规定了用于提升机时补偿滑轮直径的选择方法。
ISO 4308-1:2003 specifies two methods for the selection of wire rope to be used on lifting appliances as designated in ISO 4306-1, one based on the value of the rope selection factor C and the other based on the value of the coefficient of utilization Zp ISO 4308-1:2003 establishes the minimum requirements for acceptable strength and performance levels of wire ropes with respect to the design, application and maintenance of the lifting appliance. ISO 4308-1:2003 establishes the minimum requirements for the diameters of drums and sheaves that are to be associated with the selected wire rope.A non-exhaustive list of types of lifting appliance to which ISO 4308-1:2003 is applicable is given in Annex A.Annex B provides some examples of rope selection.Annex C gives factors, additional to those mentioned above, which may need consideration when selecting the wire rope.Annex D specifies the selection method for the diameter of the compensating sheave when used in relation to hoists.
标准预览图
