ISO/TR 11071-2:2006 全世界升降机安全标准比照 第2部分：水力升降机.

标准编号：ISO/TR 11071-2:2006

中文名称：全世界升降机安全标准比照 第2部分：水力升降机.

英文名称：Comparison of worldwide lift safety standards — Part 2: Hydraulic lifts (elevators)

发布日期：2006-04

标准范围

ISO 11071-2:20 06包括以下全球安全标准涵盖的选定主题要求的比较（不包括区域或国家偏差）:CEN欧洲标准EN 81-2:19 98升降机建造和安装安全规则第2部分:液压升降机；ASME A17.1:2004，电梯和自动扶梯安全规范和CSA B44:2004，电梯安全规范；日本——日本建筑标准法（BSLJ）；澳大利亚标准:AS 1735-1:20 03，电梯、自动扶梯和自动人行道。第1部分:一般要求；AS 1735-3:20 02，电梯、自动扶梯和自动人行道。第3部分:乘客和货物电梯。电动液压。ISO 11071-2:20 06仅适用于直接作用和间接作用类型的液压升降机。需要注意的是，除上述列出的标准外，升降机必须符合其他标准的要求（例如，涵盖机械、结构、电气设备的标准；建筑规范和环境法规）。本技术报告中将参考一些标准。

ISO 11071-2:2006 consists of a comparison of the requirements of selected topics as covered by the following worldwide safety standards (excluding regional or national deviations):

1. CEN European Standard EN 81-2:1998, Safety rules for the construction and installation of lifts -- Part 2: Hydraulic lifts;
2. ASME A17.1:2004, Safety Code for Elevators and Escalators and CSA B44:2004, Safety Code for Elevators;
3. Japan - Building Standard Law of Japan (BSLJ);
4. Standards Australia:

• AS 1735-1: 2003, Lifts, Escalators and Moving Walks - Part 1: General Requirements;
• AS 1735-3: 2002, Lifts, Escalators and Moving Walks - Part 3: Passenger and Goods Lifts - Electro-hydraulic.

ISO 11071-2:2006 applies to hydraulic lifts only, both of the direct and indirect acting type.It should be noted that, in addition to the above listed standards, lifts must conform to the requirements of other standards (for example, standards covering mechanical, structural, and electrical equipment; building codes, and environmental regulations). Some of the standards will be referred to in this Technical Report.

标准预览图