ISO 11789:1999 带有刚性切割部件的电动修边器-定义,安全要求和试验步骤.

标准编号：ISO 11789:1999

中文名称：带有刚性切割部件的电动修边器-定义,安全要求和试验步骤.

英文名称：Powered edgers with rigid cutting means — Definitions, safety requirements and test procedures

发布日期：1999-04

标准范围

本国际标准规定了适用于步行的机械安全要求和试验方法动力磨边机，采用刚性切割方式，刀尖圆直径不超过305 mm，以及其中，叶尖圆的平面设计为与垂直方向的夹角不超过15°。本国际标准适用于采用刚性切割元件的手持式便携式动力磨边机具有直径不超过305 mm的叶尖圆。本国际标准还包括噪声和振动的试验方法。本国际标准不包括采用非金属丝线或自由旋转切割方式的磨边机非金属刀具。本国际标准不包括改变机器功能的附件或附件。本国际标准不包括电动磨边机的电气方面。对于适用于电动机器的电气要求，应参考IEC 60335-1。注:有关自行式机器的运动控制要求，请参考ISO 5395。

This International Standard specifies mechanical safety requirements and test methods applicable to walk-behindpowered edgers that employ rigid cutting means with a blade tip circle not more than 305 mm in diameter, andwhere the plane of the blade tip circle is designed to operate at not more than 15° from the vertical.This International Standard applies to hand-held portable and powered edgers employing a rigid cutting elementwith a blade tip circle not more than 305 mm in diameter.This International Standard also includes test methods for noise and vibration.This International Standard does not cover edgers with cutting means of non-metallic filament line or freely pivotingnon-metallic cutters.This International Standard does not cover accessories or attachments that alter the function of the machine.The electrical aspects of electrically powered edgers are not covered by this International Standard. For theelectrical requirements applicable to electrically driven machines, reference should be made to IEC 60335-1.NOTE — For motion control requirements related to self-propelled machines, reference should be made to ISO 5395.

标准预览图