ISO 23274-1:2019 混合动力道路车辆 废气排放和燃料消耗测量 第1部分：非外部可充电车辆

标准编号：ISO 23274-1:2019

中文名称：混合动力道路车辆 废气排放和燃料消耗测量 第1部分：非外部可充电车辆

英文名称：Hybrid-electric road vehicles — Exhaust emissions and fuel consumption measurements — Part 1: Non-externally chargeable vehicles

发布日期：2019-08

标准范围

本文件规定了底盘测功机测试程序，用于测量车辆的废气排放量、电能和燃油消耗量。本文件适用于具有以下特征的车辆:-根据相关区域适用驾驶考试（ADT）标准的定义，被归类为乘用车或轻型卡车的车辆；-可再充电储能系统（RESS）的标称能量至少为ADT总能耗的2%；-内燃机（ICE）仅使用液体燃料（例如汽油和柴油）。注:对于使用其他燃料[例如压缩天然气（CNG）、液化石油气（LPG）、氢气]的装有冰的车辆，本文件可适用，但消耗燃料的测量除外；否则，可采用使用相应燃油的测量方法。本文件提出了修正混合动力汽车实测排放量和燃油消耗量的程序-当RESS的荷电状态（SOC）在ADT开始和结束之间不保持相同时，为了获得值，电动汽车（HEV）。如ISO 23274-2所述，当车辆未进行外部充电且仅在充电维持（CS）状态下运行时，它也可用于外部充电HEV的废气排放和燃油消耗的测量程序。

This document specifies a chassis dynamometer test procedure to measure the exhaust emissions and the electric energy and fuel consumption for the vehicles.

This document applies to vehicles with the following characteristics:

— vehicles classified as passenger cars or light duty trucks, as defined in the relevant regional applicable driving test (ADT) standard;

— the nominal energy of the rechargeable energy storage system (RESS) is at least 2 % of the total energy consumption over an ADT;

— internal combustion engine (ICE) only using liquid fuels (for example, gasoline and diesel fuel).

NOTE In the case of the vehicles with ICE using other fuel [for example, compressed natural gas (CNG), liquefied petroleum gas (LPG), hydrogen], this document can apply except the measurement of consumed fuel; otherwise the measurement method for those using the corresponding fuel can apply.

This document proposes procedures for correcting the measured emissions and fuel consumption of hybrid-electric vehicles (HEVs), in order to obtain the values when the state of charge (SOC) of the RESS does not remain the same between the beginning and the end of an ADT.

It can also be applied to measurement procedures for exhaust emissions and fuel consumption of externally chargeable HEVs when a vehicle is not externally charged and operated only in the charge sustaining (CS) state, as described in ISO 23274？2.

标准预览图