ISO 16810:2024 无损检测 超声波检测 一般原则

标准编号：ISO 16810:2024

中文名称：无损检测 超声波检测 一般原则

英文名称：Non-destructive testing — Ultrasonic testing — General principles

发布日期：2024-10

标准范围

本文件规定了允许超声波传输的工业产品超声波检测的一般原则。超声波测试的应用和使用的具体条件取决于待测试产品的类型，在文件中描述，这些文件可以包括:-产品标准；-规格；-代码；-合同文件；-书面程序。除非参考文件中另有规定，否则本文件规定了最低适用要求。本文件未规定:-测试和扫描计划的范围；-验收标准。该文献仅描述了常规探头，然而，超声测试的一般原理也适用于使用阵列技术的超声测试。如果使用阵列技术，则可能需要额外的步骤或验证。

This document specifies the general principles for the ultrasonic testing of industrial products that permit the transmission of ultrasound.

The specific conditions of application and use of ultrasonic testing, which depend on the type of product to be tested, are described in documents which can include:

—     product standards;

—     specifications;

—     codes;

—     contractual documents;

—     written procedures.

This document specifies the minimum applicable requirements, unless otherwise specified in the referencing documents.

This document does not specify:

—     extent of testing and scan plans;

—     acceptance criteria.

This document describes only conventional probes, however, the general principles for ultrasonic testing also apply to ultrasonic testing using array techniques. If array techniques are used, then additional steps or verifications can be needed.

标准预览图