ISO 10605:2008 道路车辆 来自静电放电的电气骚扰的试验方法

标准编号：ISO 10605:2008

中文名称：道路车辆 来自静电放电的电气骚扰的试验方法

英文名称：Road vehicles — Test methods for electrical disturbances from electrostatic discharge

发布日期：2008-07

标准范围

ISO 10605:2008规定了评估车辆用电子模块所需的静电放电（ESD）测试方法。它适用于以下情况下的出院:装配中的ESD；服务人员造成的ESD；由居住者引起的ESD。应用于被测器件（DUT）的ESD会直接影响DUT。施加到相邻部件的ESD可以耦合到车辆中的DUT的电源和信号线中和/或直接耦合到DUT中。ISO 10605:2008描述了用于评估试验台和整车上的电子模块的测试程序。它还描述了对封装和处理模块的ESD敏感性进行分类的测试程序。ISO 10605:2008适用于所有类型的道路车辆，无论推进系统如何（例如火花点火发动机、柴油发动机、电动机）。ISO 10605:2008部分基于IEC 61000-4-2，描述了特定于车辆的要求。ISO 10605:2008不适用于烟火模块。

ISO 10605:2008 specifies the electrostatic discharge (ESD) test methods necessary to evaluate electronic modules intended for vehicle use. It applies to discharges in the following cases:

• ESD in assembly;
• ESD caused by service staff;
• ESD caused by occupants.

ESD applied to the device under test (DUT) can directly influence the DUT. ESD applied to neighbouring parts can couple into supply and signal lines of the DUT in the vehicle and/or directly into the DUT.ISO 10605:2008 describes test procedures for evaluating both electronic modules on the bench and complete vehicles. It also describes a test procedure that classifies the ESD sensitivity of modules for packaging and handling. ISO 10605:2008 applies to all types of road vehicles regardless of the propulsion system (e.g. spark-ignition engine, diesel engine, electric motor).ISO 10605:2008 is based in part on IEC 61000-4-2 and describes vehicle-specific requirements.ISO 10605:2008 does not apply to pyrotechnic modules.

标准预览图