ISO 22915-1:2008 工业车辆 稳定性的验证 第1部分：总则

标准编号：ISO 22915-1:2008

中文名称：工业车辆 稳定性的验证 第1部分：总则

英文名称：Industrial trucks — Verification of stability — Part 1: General

发布日期：2008-10

标准范围

ISO 22915涉及ISO 5053中定义的工业卡车的安全性，与其稳定性和稳定性验证相关。就ISO 22915而言，工业卡车是轮式、自行式或步行式车辆，但在轨道上行驶的除外。它们由操作员控制或无人驾驶，设计用于在机架中搬运、牵引、推动、提升、堆叠或分层。ISO 22915-1:20 08规定了验证工业卡车（简称卡车）稳定性的基本测试标准和要求。它适用于以下卡车类型和特殊条件:带桅杆的平衡重卡车；前伸式和跨式卡车；1200毫米（含1200毫米）以下的托盘堆垛机、双层堆垛机和订单拣选车；单侧装载卡车；双向和多向卡车；在桅杆向前倾斜的特殊堆垛条件下运行的卡车的附加稳定性测试；带桅杆的平衡卡车，可装卸长度为6米（20英尺）或更长的货运集装箱；在特殊条件下运行的卡车的附加稳定性测试，负载被动力装置基本上横向移动；工业可变延伸卡车；处理长度为6米（20英尺）及以上货运集装箱的工业可变延伸卡车；崎岖地形可变延伸卡车；带铰接式转向的平衡卡车；行人推进的卡车；负担和人员承运人；在具有偏移负载的特殊条件下运行的卡车的附加稳定性测试，偏移由利用率确定；操作员位置提升至1200毫米以上的订单提货卡车。ISO 22915-1:20 08不适用于:搬运可自由摆动的悬挂负载的卡车；提升高度不超过500毫米的低矮叉车。

ISO 22915 deals with the safety of industrial trucks, as defined in ISO 5053, relative to their stability and the verification of that stability. For the purposes of ISO 22915, industrial trucks are wheeled, self-propelled or pedestrian-propelled vehicles, excepting those running on rails. They are either operator-controlled or driverless and designed to carry, tow, push, lift, stack or tier in racks.ISO 22915-1:2008 specifies basic test criteria and requirements to verify stability for industrial trucks, referred to simply as trucks.It applies to the following truck types and special conditions: counterbalanced trucks with mast; reach and straddle trucks; pallet stackers, double stackers and order-picking trucks up to and including 1200 mm; single side loading trucks; bidirectional and multidirectional trucks; additional stability test for trucks operating in special conditions of stacking with the mast tilted forward; counterbalanced trucks with mast handling freight containers of 6 m (20 ft) length and longer; additional stability test for trucks operating in special condition with the load substantially laterally displaced by powered devices; industrial variable reach trucks; industrial variable reach trucks handling freight containers of 6 m (20 ft) length and longer; rough terrain variable reach trucks; counterbalanced trucks with articulated steering; pedestrian propelled trucks; burden and personnel carrier; additional stability test for trucks operating in a special condition with offset load, offset determined by utilisation; order-picking trucks with elevating operator position above 1200 mm.ISO 22915-1:2008 does not apply to:

• trucks handling suspended loads which may swing freely;
• low lift trucks with lift height up to and including 500 mm.

标准预览图